Rixson H117-3/4 x 587 Heavy-Duty Center Hung Pivot Set - LTP

Customers also purchased Athmer Drop Seal

• Non-handed
• Bottom pivot is mortised into the floor
• Pivot remains constant at 2-3/4" (70mm) from the edge of the door
• Door must have radius on pivot edge
• End load arm for minimum 2" (51mm) thick doors
• Special side load arm for 1-3/4" (44mm) thick doors or for moving pivot point toward lock edge of door
• Additional surface applied thrust bearing
• NOT for use on labeled doors and frames

• Exterior or Interior Doors
• Doors up to 600 lbs
• Door Sizes up to 4'0"x 8'6" (1219 x 2591mm)

• H340 top pivot
• Sealed bearings for protection against weather and debris
• Wood and machine screws

• Available with extended spindles in 1/2" (13mm) increments up to 2" (51mm) longer than standard
• Compliance ANSI/CO7011

• JNF Hydraulic Pivot for lighter doors (220 lbs)
• JNF Spring Pivot for lighter doors (99 lbs)
• FritsJurgens Pivot Systems

Center hung pivots are door hanging means only. To close doors, see floor closers. For doors taller than 8'6" use top pivot H345 in lieu of H340